Uline TORNADO H-10400 Manual Del Usuario página 8

REPLACING THE ROLLER BRUSH
NOTE: Ensure that the bracket is always
completely opened during installation.
1. Fold the bracket on the side section fully upward
and remove the side section. (See Figure 18)
2. Pull out the old roller brush and dispose of it.
3. Insert a new roller brush in the side section.
4. Push the side section together with the roller brush
into the vacuum.
5. Fold the bracket fully downward to lock the side
section.
Side
Section 3
1
Bracket 2
REMOVING BLOCKAGE
NOTE: Remove the brush cover if necessary.
1. Insert a rod or dowel to remove blockage from
suction pipe. (See Figure 19)
Figure 19
PAGE 8 OF 28
MAINTENANCE CONTINUED
Roller Brush
Figure 18
2. Squeeze side prongs to release suction hose.
(See Figure 20)
1
2
Figure 20
3. Insert a rod or dowel to remove blockage from
suction hose. (See Figure 21)
NOTE: Debris will exit the vacuum through the
brush roll opening.
Figure 21
3
4. Reinsert hose until an audible click is heard.
(See Figure 22)
4
Figure 22
1
0323 IH-10400