Cherubini OCEAN Instrucciones página 10

ADJUSTEMENT OF THE LIMIT SWITCHES
Ocean tubular motors are provided with a system of electromechanical limit switches
that stop the feed when the awning or the rolling shutter get to the maximum opening or
closing limits. To adjust these limits and adapt them to any need, simply screw or unscrew
the two adjusting screws on the motor head. The limits of the limit switches are preset at
about three turns of the roller.
1. To decide which adjusting screw to fix, simply watch the direction of rotation of the stop
ring nut: if the stop ring nut pulled by the roller goes in direction A, use the adjusting
screw A to set the limit switch in that direction. If it goes to the opposite direction (B),
use the adjusting screw B.
2. Start up the awning or the rolling shutter in the direction in which you wish to set the
first limit switch. After a few turns the motor will stop on the preset stop.
3. Screw the adjusting screw suited to the direction (see point 1.) in direction "+" till it
gets to the chosen position.
4. Invert the engine sense of direction and set the second limit switch.
ADJUSTING SCREWS
B
A
STOP RING NUT
DECLARATION OF CONFORMITY
Hereby, Cherubini S.p.A. declares that the OCEAN motors are compliant to UE Directives:
Directive 2006/42/EC on machinery.
Directive 2014/35/EU safety of electrical equipment LVD.
Directive 2014/30/EU on electromagnetic compatibility.
The full text of the EU declaration of conformity is available upon request at the following
website: www.cherubini.it.
GB
A
B
A
B
10
STOP RING NUT
A
B