Descargar Imprimir esta página

Hitachi WP 14DSL Instrucciones De Manejo página 9

Atornillador de impulsos a batería

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 51
9.
Keep away from fire immediately when leakage
or foul odor are detected.
10. Do not use in a location where strong static
electricity generates.
11. If there is battery leakage, foul odor, heat
generated, discolored or deformed, or in any way
appears abnormal during use, recharging or
storage, immediately remove it from the
equipment or battery charger, and stop use.
CAUTION
1.
If liquid leaking from the battery gets into your
eyes, do not rub your eyes and wash them well
with fresh clean water such as tap water and
contact a doctor immediately.
If left untreated, the liquid may cause eye-
problems.
2.
If liquid leaks onto your skin or clothes, wash well
with clean water such as tap water immediately.
There is a possibility that this can cause skin
irritation.
SPECIFICATIONS
POWER TOOL
Model
Power mode
No-load speed
Save mode
Small screw
Capacity
Wood screw
Maximum torque
Rechargeable battery
Weight
NOTE:
Bolt tightening and loosening are not available.
CHARGER
Model
Charging voltage
Weight
STANDARD ACCESSORIES
In addition to the main unit (1), the package contains the
accessories listed in the table below.
1 Charger (UC18YRSL) ...................... 1
2 Battery ............................................... 2
WP14DSL
3 Plastic case ....................................... 1
(LSRK)
4 Battery cover .................................... 1
Standard accessories are subject to change without
notice.
When fully charged at 20˚C temp.
BSL1430: Li-ion 14.4 V (3.0 Ah 8 cells)
UC18YRSL
14.4 V 18 V
0.6 kg
3.
If you find rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using
the battery for the first time, do not use and return
it to your supplier or vendor.
WARNING
If an electrically conductive foreign object enters the
terminals of the lithium ion battery, a short-circuit may
occur resulting in the risk of fire. Please observe the
following matters when storing the battery.
Do not place electrically conductive cuttings, nails,
steel wire, copper wire or other wire in the storage
case.
Either install the battery in the power tool or
store by securely pressing into the battery cover
until the ventilation holes are concealed to prevent
short-circuits (See Fig. 1).
WP14DSL
0 – 2600 min
0 – 2000 min
M4 – M8
ø3.5 – ø9.5
Power mode: 30 N·m (306 kgf·cm)
Save mode: 16 N·m (163 kgf·cm)
Tightening time: 1 sec.
1.6 kg
OPTIONAL ACCESSORIES
(Sold separately)
1. Plus driver bit
Bit No.
No. 2
No. 3
2. Wood working drill: Code No. 959183
English
–1
–1
Code No.
992671
992672
8

Publicidad

loading