CELME TOP 220 Instalación Uso Y Mantenimiento página 13

6) SHARPENING AND LUBRICATION
6.1 SHARPENING
This is a very important operation to carry out every time the cutting is not clean, or when the blade drags the
slice.
The use and the type of products that have been sliced determine the periodicity of this operation.
1. Plug the machine
2. Open with the handle the maximun slice size (15 mm.)
3. Lift the sharpener on the carriage in the correct position. fig.16
6.1.1 SHARPENING
(FOR MOD TOP 220-250-275-275XXL WITH SHARPENER AS DEVICE)
Before shappening the blade, clean the machine and degrease the blade accurately.
1. Plug the machine
2. Open with the handle the maximin slice size (15mm)
3. Lift the sharpener on the carriage. (Fig.16)
4. Put the sharpener to take the blade between the two grinding wheels.
5. Keep button "A" pressed for 5/10 seconds to sharpen. (Fig.17)
6. Keep button "B" pressed for a few seconds tu deburr. (Fig.18)
7. Stop the machine and return the shrpener in its initial position.
6.1.2 SHARPENING WITH MOD TOP 300 (WITH FIXED SHARPENER)
Before shappening the blade, clean the machine and degrease the blade accurately.
1. Plug the machine
2. Lift the sharpener and turn it by 180° to take the blade between the two grinding wheels. (Fig.19)
3. Keep button "A" pressed for 5/10 seconds to sharpen.
4. Keep button "B" pressed for a few seconds tu deburr.
5. Stop the machine and return the shrpener in its initial position.(Fig.20-21-22)
WARNING: use the button "A" to sharpen and the button "B" to dribble the cutting edge of the blade.
During the sharpening process keep to the original drawing of the blade level. Replace the blade when the
clearance between the ring and blade exceeds 6mm
6.2 LUBRICATION
Periodically lubricate the sliding elements with white vaseline oil.
For not damaging the slicer, never use seed oil or olive-oil. lubricate all elements using the oilers as shown in
fig.7
6.3 MACHINE IDLE FOR A LONG TIME
Should the machine be idle for a long time, disconnect the wall main switch and clean the machine and its
accessories accurately.
Use white vaseline oil (or similar products) to protect all the machine elements. We advise covering the
machine with a nylon (or similar) cloth.
13