GGP ITALY MP 24 Li Manual De Instrucciones página 135

Warning! Read the instructions
before operating the machine.
Warning! Failure to use this
machine correctly can be
hazardous for oneself and others
Danger! Do not leave the machine
in the rain (or in damp conditions).
Danger! Always wear
the gloves when use
the chain saw.
Warning! Beware of
falling objects.
Keep bystanders away.
Danger! Electrocution hazard.
Keep at least 10 m away
from overhead lines.
Danger! Always wear head and
eye protection..
Danger! Wear non-slip
safety footwear..
Danger! Always wear ear
and eye protection.
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an authorised service centre.
3.3 IDENTIFICATION LABEL
The identification label holds
the following data (fig. 1):
1. Sound power level
2. CE conformity marking
3. Year of manufacture
4. Type of machine
5. Manufacturer's reference model
6. Serial number
7. Name and address of Manufacturer
8. Article code
9. Guide bar lenght
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Quote the information on
the product identification label whenever you
contact an authorized service workshop.
IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.
3.4 MAIN COMPONENTS
The machine is composed of a series
of main components that have the
following functions (fig.1):
A. Motor: supplies the drive power
to the cutting means.
B. Comands rod: is fitted with
the main switch controls..
C. Rear handgrip: support handgrip located
on the rear of comands pole. This should
be grasped using the right hand.
D. Front handgrip: support handgrip
located on the rod commands. This
should be grasped using the left hand.
E. Pruner device:. device designed to
limbing and draining of trees.Is supplied
already mounted on the pole.
F. Harness: cloth belt that passes over
the shoulder, helps support the weight
of the machine while working. May only
be used with the extension pole.
G. Guide bar: supports and
guides the toothed chain.
H. Toothed chain: cutting element,
consisting of drive links fitted with
small blades called "teeth" and side
connections held in place by rivets.
I. Chain restraint pin: safety device that
prevents uncontrolled movements of the
toothed chain should it break or slacken.
J. Extension tube: element that allows to
increase the length of the machine.
K. Bar cover guard: chain saw cover on
the guide bar to be fitted during handling,
transportation or storage of the machine.
L. Battery: (if it is not supplied with the
machine, see chapter 15 "Accessories
on request") device that supplies
electric current to the tool; its
specifications and regulations for use
are described in a specific manual.
M. Battery charger: (if it is not supplied
with the machine, see chapter 15
"Accessories on request") device
used to recharge the battery.
4. ASSEMBLY
The safety regulations to follow
are described in chap. 2. Strictly
EN - 6