Publicidad
Step 12
Before fastening the DOOR to your unit, be sure the mounting screw
å
is against the stops as shown in the right diagram. If it isn't, loosen
the mounting screw to slide it against the stops. Then tighten the
mounting screw.
Fasten the LEFT DOOR (I) to the LEFT UPRIGHT (D) as shown in the
å
lower diagram. Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
Fasten a KNOB (87K) to the LEFT DOOR (I). Use a SILVER 1-1/8"
å
FLAT HEAD SCREW (10S).
Repeat this step for the other DOOR (H).
å
See the next step for DOOR adjustments.
å
B
87K
SILVER 1-1/8" FLAT HEAD SCREW
(2 used for the KNOBS)
Page 16
D
I
10S
403679
Stop
Mounting
screw
Hinge
A
www.sauder.com/services
Publicidad
