Publicidad
Idiomas disponibles
Idiomas disponibles
LIGHT BULB REPLACEMENT
The appliance comes with a white LED light. To replace the LED light strip:
• Contact customer service for information on purchasing a replacement LED light strip.
• Remove the two screws holding the light control box and remove the box.
• Remove the light cover and then remove the light strip.
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any length of time during
this process, it must remain upright for six hours before plugging it in to
avoid damage to the internal components.
A #2 cross-head screwdriver (not supplied) is required to reverse the door.
1. Remove the hinge cover and the upper hinge from the top right side of
the wine cooler. Remove the door from the wine cooler.
2. Remove the screw hole covers from the top left side of the wine cooler
and install them on the top right side of the wine cooler.
3. Remove the hinge hole cover from the top left side and install on the top
right side of the door.
4. Remove the solid foot from the bottom left side of the wine cooler.
Remove the adjustable foot and the lower hinge from the bottom right
side of the wine cooler. Install the solid foot on the bottom right side of
the wine cooler. Install the adjustable foot and the lower hinge on the
bottom left side of the wine cooler.
5. Install the door on the cabinet. Install the upper hinge and the hinge cover
on the top left side of the wine cooler.
Note: When reinstalling the door, ensure that the top of the door is level
with the top of the cabinet and that the rubber gasket makes a good seal
with the wine cooler all the way around.
26
Publicidad
