Publicidad
Idiomas disponibles
Idiomas disponibles
Become familiar with these terms before operating the
unit.
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of
measure of air delivery.
PSIG: Pounds per square inch gauge; a unit of meas-
ure of pressure.
ASME: American Society of Mechanical Engineers;
made, tested, inspected and registered to meet the
standards of the ASME.
Code Certification: Products that bear one or more
of the following marks: UL, CUL, ETL, CETL, have
been evaluated by OSHA certified independent safety
laboratories and meet the applicable Underwriters
Laboratories Standards for Safety.
This unit is capable of powering the following Accessories. The accessories are available through the current
Power and Hand Tool Catalog or full-line Sears stores.
Accessories
•
In Line Filter
•
Tire Air Chuck
•
Quick Connector Sets
(various sizes)
•
Air Pressure Regulators
•
Oil Fog Lubricators
•
Air Hose:
1/4", 3/8" or 1/2" I.D.
in various lengths
Specialty Tools
•
Inflating/Blow Gun
•
Grease Gun
Contents of Carton
1 - Air Compressor
1 - Handle
4 - Self Tapping Screws
2 - Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - 1/4-20 Hex Nuts
2 - Flat Washers
2 - Rubber Bumpers
2 - Screws, 1/4-20 x .75
GLOSSARY
ACCESSORIES
•
Caulk Gun
•
Engine Cleaner
•
Sand Blaster
Carpentry Tools
•
Finishing Nailer / Stapler
•
Construction Nailer /
Stapler
Socket Driving
•
1" Impact Wrench
•
3/4" Impact Wrench
•
1/2" Impact Wrench
•
3/8" Impact/Butterfly
Wrench
ASSEMBLY
Cut-In Pressure: While the motor is off, air tank
pressure drops as you continue to use your accesso-
ry. When the tank pressure drops to the factory set
low pressure the motor will restart automatically. The
low pressure at which the motor automatically restarts
is called "cut-in" pressure.
Cut-Out Pressure: When an air compressor is
turned on and begins to run, air pressure in the air
tank begins to build. It builds to a factory set high
pressure before the motor automatically shuts off -
protecting your air tank from pressure higher than its
capacity. The high pressure at which the motor shuts
off is called "cut-out" pressure.
Branch Circuit: Circuit carrying electricity from elec-
trical panel to outlet.
•
1/2" Ratchet
•
3/8" Ratchet
•
1/4" Ratchet
Material Shaping
•
2.625" Hammer
•
1.625" Hammer
•
1/2" Drill
•
3/8" Drill
•
High Speed Rotary
•
Mini High Speed Rotary
•
Cut-Off Tool
•
Shear
•
4" Angle Grinder
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - 3/8" socket or open end wrench
1 - 1/4" socket or open end wrench
7 - ENG
•
Reciprocating Saw
•
Nibbler
Spray Painting
•
Multi-Purpose Spray
Gun
•
Automotive Spray Gun
•
HVLP Spray Gun
Finishing/Sanding
•
High Speed Sander
•
Random Orbit Sander
•
6" DA Sander
•
Jitterbug Sander
•
Straight Line Sander
D24305
Publicidad
