Bosch 0 601 2B4 000 Manual Original página 19

the specifications provided by the manufacturer of the
application tool. It must not be less than the maximum
speed of the power tool.
Dust/Chip Extraction
Dust from materials such as lead-containing coatings, some
wood types, minerals and metal can be harmful to one's
health. Touching or breathing-in the dust can cause allergic
reactions and/or lead to respiratory infections of the user or
bystanders.
Certain dust, such as oak or beech dust, is considered carci-
nogenic, especially in connection with wood-treatment ad-
ditives (chromate, wood preservative). Materials containing
asbestos may only be worked by specialists.
– Provide for good ventilation of the working place.
– It is recommended to wear a P2 filter-class respirator.
Observe the relevant regulations in your country for the ma-
terials to be worked.
Avoid dust accumulation at the workplace. Dust can
u
easily ignite.
Operation
Starting operation
Switching On and Off
To start the power tool, slide the on/off switch (5) forwards.
To lock the on/off switch (5) in position, push the on/off
switch (5) forwards and down until it clicks into place.
To switch off the power tool, release the on/off switch (5);
or, if the switch is locked, briefly push the on/off switch (5)
backwards and down and then release it.
Speed preselection
You can use the button for speed preselection (16) to preselect the required speed, even during operation. The information in
the table below describes the recommended values.
Material Application
Metal Milling
Metal Grinding
Metal Removing rust
Metal Grinding
Metal Grinding
Stainless steel Grinding
Metal Grinding
Metal Grinding
The values specified for speed levels are guide values.
The rated speed of the accessory must be at least
u
equal to the maximum speed marked on the power
Bosch Power Tools
Inserting the Battery
Do not use force to insert the battery. The battery is de-
u
signed in such a way that it can only be inserted into the
power tool when it is in the right position.
Push the charged battery into the battery holder until it
clicks into place.
Kickback Stop
the off position and then switch the power tool on again.
Restart Protection
The restart protection feature prevents the power tool from
uncontrolled starting after the power supply to it has been
interrupted.
To restart the tool, set the on/off switch (5) to the off posi-
tion and then switch the power tool on again.
Note: Rapidly switching the power tool off and on again may
trigger the restart protection, meaning the power tool may
not start up even if the on/off switch (5) is pressed. Set the
on/off switch (5) to the off position and then switch the
power tool on again.
Impact shutdown
The integrated impact shutdown switches the power tool off
as soon as it hits the floor. The status indicator (17) then
flashes red. To restart the tool, set the on/off switch (5) to
the "off" position and then switch the power tool on again.
User interface (see figure B)
The user interface (13) is used to preselect the speed and to
indicate the status of the power tool.
Tools Speed preselection
level
Router bits 3
Grinding stones 3
Brush 1
Abrasive sleeves 3
Fan grinders, corundum A 2
Fan grinders, stainless 2
steel
Fleece tools 1
Fleece tools, abrasive 1
wheels
tool. Accessories running faster than their rated speed
can break and fly apart.
If there is a sudden kickback in the power tool,
e.g. jamming when carving, the power supply
to the motor will be interrupted electronically.
To restart the tool, set the on/off switch (5) to
-1
[min ]
10,500
10,500
4500
10,500
7500
7500
4500
4500
1 609 92A 6DP | (15.06.2021)
English | 19