Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Screw the sanding disc on the orbit sander.
2.
Block/Secure the sanding disc.
8.2
Speed adjustment (Fig. 3)
The rotation speed adjustment can be made by opening / closing the tap near the air inlet.
9
TECHNICAL DATA
Model
No load speed
Operating pressure
Diam. connection air inlet
Average air consumption
Weight
Diam. sanding disc
10
SOUND EMISSION
Noise emission values measured according to relevant standard.
LpA (Sound pressure level) :
LwA (Sound power level) :
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration) :
11
TROUBLE SHOOTING
The following form lists the common operating system with problem and solutions. Please
read the form carefully and follow it.
WARNING:If any of the following symptoms appears during your operating,
stop using the tool immediately, or serious personal injury could result.
Only a qualified persons or an authorized service center can perform
repairs or replacement of tool.
Disconnect tool from air supply before attempting repair or adjustment.
When replacing O-rings or Cylinder, lubricate with air tool oil before
assembly.
PROBLEMS
Tool runs at
normal speed
Copyright © 2021 VARO
POWAIR0013
POSSIBLE CAUSES
Motor parts worn.
P a g e
POWAIR0013
Max. 10 500 min-1
6,3 bar
¼"
240 l/min
1,4 kg
150 mm
86 dB(A)
97 dB(A)
6,6 m/s²
REMEDIES
Lubricating clutch housing.
Check for excess clutch oil. Clutch
cases need only be half full. Overfilling
| 4
K = 1.5m/s²
www.varo.com
EN
Publicidad
