Push Rod Inspection; Push Rod Installation - YAMAHA Marine F4A Manual De Servicio

POWR
1
2
CYLINDER HEAD AND PUSH ROD

Push rod inspection

1. Measure:
9 Push rod runout
Out of specification ® Replace the
defective part.
Push rod runout limit:
0.5 mm (0.02 in)

Push rod installation

1. Loosen:
9 Locknut (rocker arm)
9 Valve adjuster
2. Install:
9 Cylinder head gasket
(to cylinder body)
9 Cylinder head ass'y
Push rod 1
9
NOTE:
When installing the push rod 1, check it's
9
connect position on the holder 2 of valve
lifter.
9 Adjust valve clearance after installing
push rods.
5-14
E