Bosch TASSIMO FIEDLIA TAS40 Serie Instrucciones De Uso página 30

28
Problem
O
Automatic mode
skipped, appliance
goes straight to
N
Manual mode.
The quality of
the crema has
deteriorated.
Brewing unit cannot
be securely closed.
Water dripping from
the brewing unit.
Water on the surface
under the cup stand.
Service T DISC is
damaged or lost.
More Customer Service information is available online at www.tassimo.com
Robert Bosch Hausgeräte GmbH
Possible!cause
The barcode could not be
detected.
The drink outlet is clogged or
dirty.
Piercing unit / T DISC holder
is not properly inserted.
The T DISC is not inserted
properly.
The brewing unit is not
properly closed.
The T DISC is damaged or
leaky.
The piercing unit is either
not inserted or not inserted
properly.
Water from condensation.
The Service T DISC must
always be used for cleaning
and descaling processes.
Solution
Clean the bar code reading
window.
Use another T DISC.
You can still prepare the drink
by holding down the start / stop
button.
Remove the drink outlet
from the brewing unit and
detach the piercing unit.
After cleaning everything
thoroughly, reassemble the
parts and replace them in the
brewing unit.
Insert the T DISC holder and
piercing unit properly.
Re­insert the T DISC and
make sure it is properly
positioned.
Push the clamp down firmly
until it audibly clicks into
place.
Stop the brewing process,
remove the T DISC and clean
the brewing unit.
Check to ensure that the
piercing unit is inserted
properly.
Condensation may occur and
is not a fault. Remove it by
wiping with a cloth.
Look for the Service T DISC
in the storage compartment at
the back of the appliance.
The Service T DISC can be
obtained from the Bosch
customer service department
(article no. 611632, for contact
details, see page 150).
en