Publicidad
Idiomas disponibles
Idiomas disponibles
1
2
3
4
2
3
4
5
10.3.
Set Weight
CAUTION
Please make sure to always select the correct weight (and the correct number of axles) before your trip
starts. If weight and axles are not correctly set, you risk enforcement procedures and high penalties to be
paid by the user.
The OBU allows the numerical setting of the weight in Tons in steps of 100kg. Please round up the weight to
the next 100kg.You can only select a weight which is between:
• the maximum permissible weight of the tractor (The weight can be found in F.2. on the vehicle certificate
and on the vehicle manufacturers plate).
• and the maximum permissible weight of the vehicle combination (The weight can be found in F.3. on the
vehicle certificate and on the vehicle manufacturers plate).
The weight to be set must equal the maximum permissible weight of the tractor (F.2. of the tractor)
plus the maximum permissible weight of the trailer (F.2. of the trailer currently in use). When entering
the weight set submenu (this happens automatically after first switch-on) the weight editor always starts
with the highest (most left) digit. The value of the digit can be changed by using the and navigation
buttons. To move to the next lower digit, use the Selection button . After setting the lowest (most right)
digit, confirm the weight selection with the Selection button (press twice until reaching the main menu).
In case you want to change a higher digit again, use the Cancel button × to move back to the next left digit.
• the button allows to navigate on the menu from left to right
• the and buttons allow to increment and decrement the values of the weight
• the x button allows to navigate from right to left
• Once the lowest digit is set, a confirmation is required by pressing "" button twice to get back to the
main menu
The following example shows the weight setting of a vehicle with an F.2 tractor weight of
7,9t if a trailer with F.2 equal to 1,6 tons is hitched up. In this case the actual weight of the
vehicle combination to be set is 9,5t.v
1
7.9t
Editor starts at the
highest digit
24
2
2
3
4
2
Press to move to the
next right digit
The number of axles can be set in eight different steps.
The minimum selectable number corresponds to the
number of axles of the tractor vehicle. If you use a
trailer, the additional axles of the vehicle combination
must be set in increments of one up to a number of
7 trailer axles. Please always enter the axles number
corresponding to the sum of the number of axles of
the tractor and the trailer.
2+1=
3
2+2=
4
3+2=
5
3
9.9t
Use arrow keys to
change the value
4
9.9t
Press to move to the
next right digit
Publicidad
