Hilti SID 4R-22 Manual De Instrucciones página 36

5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Changing the accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
1. Check that the connection end of the accessory tool is clean. Clean the
connection end if necessary.
2. To insert the accessory tool push it into the tool holder as far as it will
go, until the locking sleeve engages with an audible click. Check that the
accessory tool is held securely.
3. To remove the accessory tool, pull the locking sleeve forward and hold
it in this position.
4. Pull the accessory tool out of the tool holder and release the locking
sleeve.
5.5 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether
for possible damage.
▶ Do not secure a tool tether to the belt hook. Do not use a belt hook to lift
the product.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining
strap and the Hilti tool tether #2261970.
▶ Secure the retaining strap to the installation openings for accessories.
Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure
the second carabiner to a load-bearing structure. Check that both
carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap
and those of the Hilti tool tether.
32 English
2
2373958
*2373958*