Descargar Imprimir esta página

Hilti SID 4R-22 Manual De Instrucciones página 39

Ocultar thumbs Ver también para SID 4R-22:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 78
isolated from any conductive materials or other batteries that may come
in contact with the terminals and cause a short circuit. Comply with the
locally applicable regulations for transporting batteries.
▶ Do not send batteries through the mail.
instructions on how to ship undamaged batteries.
▶ Prior to each use and before and after prolonged transport, check the
product and the batteries for damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with
the temperature limits stated in the technical data.
▶ Do not store batteries on the charger. Always remove the battery from
the charger when the charging operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind
glass.
▶ Store the product and batteries where they cannot be accessed by
children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the
product and the batteries for damage.
9
Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See
the section headed Status indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable
to rectify the problem by yourself, contact Hilti Service.
Trouble or fault
Product does not
work.
Running speed sud-
denly drops consid-
erably.
The battery runs
down more quickly
than usual.
The battery does
not engage with an
audible click.
*2373958*
Possible cause
The battery is not fully
inserted.
Battery is discharged.
Very low ambient tem-
perature.
The retaining lugs on the
battery are dirty.
2373958
Consult your shipper for
Action to be taken
▶ Push the battery in
until it engages with
an audible click.
▶ Change the battery
and charge the empty
battery.
▶ Allow the battery to
warm up slowly to
room temperature.
▶ Clean the retaining
lugs and engage the
battery in the working
position.
English
35

Publicidad

loading