Publicidad
Idiomas disponibles
Idiomas disponibles
Installing and removing dust
extraction hose
Attach the hose elbow to the upper port with the lock
button facing upwards. Insert the sleeve of the hose into
the lower port, pressing and aligning the stopper but-
tons on the sleeve with the guide notches on the port.
Make sure that the elbow and sleeve fit properly to the
ports of the tool.
5
4
► 1. Dust extraction hose 2. Elbow 3. Lock button
4. Sleeve 5. Upper Port 6. Lower Port
To remove the hose elbow from the port, pull the elbow
while pressing down the lock button.
► 1. Lock button 2. Elbow
3
2
6
1
2
To remove the sleeve of the hose from the port, pull the
sleeve while pressing the stopper buttons on both sides
of the port.
► 1. Stopper button 2. Sleeve
1
Bench mounting
When the tool is shipped, the handle is locked in the
lowered position by the stopper pin. While lowering the
handle slightly, pull the stopper pin and rotate it 90°.
1
3
► 1. Locked position 2. Unlocked position 3. Stopper
pin
10 ENGLISH
2
1
2
Publicidad
