Publicidad
Idiomas disponibles
Idiomas disponibles
Table (B)
–
Molding
position in
the figure
For inside
(a)
corner
(b)
For outside
(c)
corner
(d)
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
•
Tilt and secure bevel angle setting to 33.9° LEFT.
•
Adjust and secure miter angle setting to 31.6°
RIGHT.
•
Lay crown molding with its broad back (hidden)
surface down on the turn base with its CEILING
CONTACT EDGE against the guide fence on the
saw.
•
The finished piece to be used will always be on
the LEFT side of the blade after the cut has been
made.
In the case of right bevel cut
(a) (b)
1. Inside corner 2. Outside corner
Table (A)
–
Molding
Bevel angle
position
52/38°
in the
type
figure
For
(a)
Right
inside
33.9°
corner
(b)
For
(c)
outside
(d)
corner
Molding
Finished
edge against
piece
guide fence
Ceiling
Finished
contact edge
piece will be
should be
on the Left
against guide
side of blade.
fence.
Wall contact
edge should
Finished
be against
piece will be
guide fence.
on the Right
Ceiling
side of blade.
contact edge
should be
against guide
fence.
(c) (d)
1
2
Miter angle
45° type
52/38°
type
Right
Right
30°
31.6°
Left
31.6°
Right
31.6°
Table (B)
–
For inside
corner
For outside
corner
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
•
Tilt and secure bevel angle setting to 33.9° RIGHT.
•
Adjust and secure miter angle setting to 31.6°
RIGHT.
•
Lay crown molding with its broad back (hidden)
surface down on the turn base with its WALL
CONTACT EDGE against the guide fence on the
saw.
•
The finished piece to be used will always be on
the RIGHT side of the blade after the cut has been
made.
45° type
Right
35.3°
Left
35.3°
Right
35.3°
29 ENGLISH
Molding
Molding
position in
edge against
the figure
guide fence
(a)
Wall contact
edge should
be against
guide fence.
(b)
Ceiling
contact edge
(c)
should be
against guide
fence.
(d)
Wall contact
edge should
be against
guide fence.
Finished
piece
Finished
piece will be
on the Right
side of blade.
Finished
piece will be
on the Left
side of blade.
Publicidad
