Publicidad
Step 1
Assemble your unit on a carpeted fl oor or on the empty carton to avoid scratching your unit or the fl oor.
å
NOTE: You should start each SCREW a few turns before completely tightening any of them.
å
Insert the LOWER END (E) into the UPPER END (D).
å
Then, fasten the UPPER END (D) to the LOWER END (E). Use four 1/2" ALLEN SCREWS (3) and the ALLEN WRENCH (8).
å
Repeat this step for the other ENDS (D and E).
å
420277
Look for this icon. It means a
video assembly tip is available at
www.sauder.com/services/tips
3
1/2" ALLEN SCREW
(8 used in this step)
D
www.sauder.com
D
8
E
E
Page 5
Publicidad
