Publicidad
Step 3
Step
NOTE: You should start each SCREW a few turns before completely tightening any of them.
å
Fasten the TOP (A) and SHELVES (B and C) to the ENDS (D and E). Use twenty 1-1/8" SCREWS (2).
å
NOTE: The TOP (A) is larger than the SHELVES (B and C). The UPPER SHELF (B) is fi nished on both sides. Be sure to
å
position these parts exactly as shown in the diagram below.
NOTE: Do not overtighten the SCREWS.
å
A
D
420277
D
B
C
E
www.sauder.com
C
C
E
2
1-1/8" SCREW
(20 used in this step)
Page 7
Publicidad
