Publicidad
Idiomas disponibles
Idiomas disponibles
Operating instructions
Always keep a fi rm grip on the
equipment with booth hands
and watch your feet. The tines
(7) may cause an accident.
Be careful while moving back-
wards – danger of tripping!
Do not touch the gearbox, as
it may become hot during op-
eration – danger of burns!
Switch the equipment off after work-
ing with it and for transport; discon-
nect from the mains and wait for
the tines (7) to stop moving.
To avoid damage to the
equipment:
• Never lift or drag the equipment with
the motor running.
• Lift the equipment while moving it over
hard surfaces such as tiles or steps.
• Walk the equipment through the soil at
normal pace and in a line as straight as
possible.
• Always work away from the mains
socket. Make sure that the cable is kept
well away from the working area.
• You can optionally remove the two ou-
ter choppers (7) to reduce the working
width, see Figure
1. Pull the safety clip over the bolt (15)
and pull the bolt (15) out.
2. Pull the outer section of the chopper
(7) from the drive shaft (16).
Overload protection: The motor
will cut out immediately if overload-
ed. The equipment cannot be used
until it has completely cooled down
again.
:
Cleaning/Maintenance
Always return the equipment to
the service centre for work not
described in the manual. Only use
original parts.
Switch the equipment off, unplug
it from the mains, and wait for the
tines (7) to stop moving before
carrying out any maintenance or
cleaning work on the equipment.
Perform regular maintenance and cleaning
on the equipment. This will ensure long,
reliable service.
General cleaning and
maintenance work
Do not spray the equipment
down with water (especially
not under pressure), and do not
clean it under running water.
Wear protective gloves when carry-
ing out maintenance and cleaning
work on the equipment to avoid
injury from cuts.
Always clean the equipment thoroughly after
each use. Always keep the equipment clean.
Do not use cleaning fl uids or solvents.
• Remove any soil and dirt residues stuck
to the tines (7), driveshaft (
equipment surface and vents with a
brush or dry cloth.
• Spray or rub biodegradable oil into the
tines (7).
• Clean soiled grips with a damp cloth.
• Always check the equipment for obvious
damage such as loose, worn or dam-
aged parts before using it. Check that
GB
MT
16),
29
Publicidad
