Troubleshooting - Pioneer DCS-222K Manual De Instrucciones

40

Troubleshooting

6
Troubleshooting
PROBLEM
No Picture
There is little or no
sound
The DVD picture
quality is poor
A DVD/CD will not
play
Noise heard while
a DVD or CD is
playing
Radio stations can't
be tuned in properly
6
The remote control
doesn't work well/at
all
The DVD receiver's
power turns off
automatically
No sound from the
microphone
HDMI output does
not display TV image
Audio volume
goes down during
playback
CAUSE
The TV is not set to receive the DVD signal.
The video cables are not connected securely.
The audio cables are not connected to the
DVD Receiver securely.
Speaker cables are not connected correctly.
The disc is dirty.
An unplayable disc is inserted.
The disc is inserted upside down.
The disc is dirty.
The DVD receiver is located too close to the
TV, causing feedback.
The antenna is positioned or connected
poorly.
The signal strength of the radio station is too
weak.
No stations have been preset or preset
stations have been cleared (when tuning by
scanning preset channels).
The remote is not pointed directly at the unit.
The remote is too far from the unit.
There is an obstacle in the path between the
remote control and the unit.
The battery in the remote control is flat.
The Auto Power Off is set to On.
KARAOKE function is not valid.
TV is not compatible with the HDMI
Resolution.
The function that lowers the volume to prevent
malfunction has automatically activated to turn
the volume down as continuing to play at high
volume will lead to the unit malfunctioning.
CORRECTION
Select the appropriate video input mode on the TV
so the picture from the DVD Receiver appears on the
TV screen.
Connect the video cables securely to both the TV
and DVD Receiver.
Connect the audio cables into the connection
terminals correctly.
Connect speaker cables correctly.
Clean the disc using a soft cloth with outward strokes.
Insert a playable disc (see page 8 for details).
Place the disc with the label or printed side facing
upwards.
Clean the disc using a soft cloth with outward strokes.
Move DVD receiver and audio components further
away from your TV.
Check the antenna connection and adjust its position.
Attach an external aerial if necessary.
Tune to the station manually.
Preset some radio stations, see page 30 for details.
Point the remote directly at the unit.
Use the remote within 7 m of the DVD receiver.
Remove the obstacle.
Replace the battery with new ones.
If Auto Power Off is set to On, this unit will
automatically turn off if no operation is performed for
30 minutes or more. Set Auto Power Off to Off to turn
this feature off (see page 25).
Validate KARAOKE function (see page 37).
Press RESOLUTION on the remote control and
change the HDMI Resolution.
It is not a malfunction. Adjust the volume on the
unit or the remote control to recover the volume.
However, continuing to play at high volume may
force the same function to activate again.