Makita CF003G Manual De Instrucciones página 9

PARTS DESCRIPTION
► Fig.1
1 Air volume control switch
4 Air volume indicator
7 Vertical angle fixing knob
10 13V DC socket
* These parts may be stored in the accessory case when shipped from the factory.
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the appli-
ance is switched off and the battery cartridge is
removed before adjusting or checking function on
the appliance.
Installing or removing battery
cartridge
CAUTION:
Always switch off the appliance
before installing or removing of the battery
cartridge.
CAUTION:
Hold the appliance and the bat-
tery cartridge firmly when installing or removing
battery cartridge. Failure to hold the appliance and
the battery cartridge firmly may cause them to slip off
your hands and result in damage to the appliance and
battery cartridge and a personal injury.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click.
To remove the battery cartridge, slide it from the
appliance while sliding the button on the front of the
cartridge.
► Fig.2: 1. Button 2. Battery cartridge (18V) 3. Battery
cartridge (36V - 40V max)
CAUTION:
Always install the battery cartridge
fully. If not, it may accidentally fall out of the appli-
ance, causing injury to you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
NOTE: Up to two battery cartridges can be installed,
although the appliance uses one battery cartridge for
operation.
NOTE: When two battery cartridges are installed, the
battery cartridge (36V - 40V max) is used first.
2 Auto-off timer button
5 Auto-off timer indicator
8 Accessory case
11 AC adaptor *
Indicating the remaining battery
capacity
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
► Fig.3: 1. Indicator lamps 2. Check button
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Appliance / battery protection
system
The appliance is equipped with the protection system.
This system automatically cuts off power to the motor
to extend appliance and battery life. The appliance will
automatically stop during operation if the appliance or
battery is placed under one of the following conditions.
•
9 ENGLISH
3 Oscillation button
6 Oscillation indicator
9 Battery slot
12 Power source cord *
Indicator lamps
Lighted Off
Overload protection : When the appliance or
battery is operated in a manner that causes it to
draw an abnormally high current, the appliance
automatically stops without any indication. In
this situation, turn the appliance off and stop the
application that caused the appliance to become
overloaded. Then turn the appliance on to restart.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.