MIYOTA GP03 Manual Del Usuario página 4

2nd time correction( 〃)
Power conservation switch
Second hand stopping devise : Pull out the crown to the second click position
2. SEPARATED PARTS
* Setting stem
Length of movement center to stem end... 2 3.00mm
Thread.................................
3. Others
* Measurement of time rate
The unit(gate) time of measurement must be set at "10s " or integer fold
value of 10s owing to the DFC system, and the measurement must be
performed in the form of complete watch.
* Marking on movement
MIYOTA CO. UNADJUSTED
NO JEWEL JAPAN GP**
* Typical clearance
Mov't - Caseback
Top of hands - Glass
* depending and subject to the glass and case structure, and hand length
4. Notice Of Casing
The interval between Dial and Glass end should be 150μm to avoid breakage
under drop.
: Pull out the crown to the first click position,
turn crown counter-clockwise.
: Pull out the crown to the second click position
065-992
Ф0.9 x 10.5mm
minimum 200 µm or more
300 - 400 µm *