Publicidad
Idiomas disponibles
Idiomas disponibles
JAF SR / JAF AS
•
Open the package and remove the upper packaging materials.
•
Raise and fix the steering column by folding the closing lever.
•
Connect the display power cable to the main wiring (if necessary).
•
Install the handlebars on the steering column paying attention to the cables, insert the 4 screws and tighten them with
the hex wrench.
•
Take the item out of its packaging.
•
Open the kickstand and check that the item is stable.
•
Perform adjustment of the steering column locking mechanism (if necessary*).
•
Check the tyre pressure (see the side of the tyre for the recommended value).
*Steering column stability – JAF
JAF SR
JAF AS
JXP
•
Open the package and remove the upper packaging materials.
•
Raise and secure the steering column by turning the locking mechanism screw clockwise.
•
Connect the display power cable to the main wiring (if necessary).
•
Install the handlebars on the steering column paying attention to the cables, insert the 4 screws and tighten them with
the hex wrench.
•
Take the item out of its packaging.
•
Open the kickstand and check that the item is stable.
•
Check the stability of the steering column and, if necessary, further tighten the relative screw of the locking
mechanism.
•
Check the tyre pressure (see the side of the tyre for the recommended value).
CAUTION
Assemble the item correctly. If, during assembly, any factory defects are detected, certain steps are unclear or issues with
assembly or adjustments occur, do not ride the vehicle and contact your dealer or visit www.jeepurbanemobility.com/en for
technical support.
Do not use accessories and/or additional parts that are not approved by the manufacturer.
Keep children away from plastic items (including packaging materials) and small parts that may result in suffocation.
It is forbidden to modify or transform the item or any its parts in any way, as this may impair efficiency, reduce structural
integrity and cause damage. Remove any sharp edges caused by misuse, breakage or damage to the item. If any factory
defects, unusual noises or faults are detected, do not ride the vehicle and contact your dealer or visit
www.jeepurbanemobility.com/en for technical support.
The locking mechanism contains a hex screw. If the handlebar
stem is not very stable after closing, adjust the screw in the
mechanism, by tightening or loosening it as required to increase
the stability of the stem.
10
Publicidad
