Jeep JUC AS Manual De Uso página 9

Assembled item, the handlebar must be installed using the special screws contained in the package.
Model Reference picture
JUC AS
JAD AS
JAF SR
JAF AS
2. Package contents and assembly
In the package
1x Allen key 1x
Charger 4x
Handlebars screws
1x Inner tube
1 Cable-cover plate 1x
Transport hook 1x
Adaptor for inflating tyres
1x Electronic buzzer
(JE-MO-220008 only)
1x Allen key 1x
Charger 4x
Handlebars screws
1x Inner tube
1x Adaptor for inflating
tyres
08
Indications
1. Raise the steering column
and insert the handlebars
taking care not to damage the
buzzer and avoiding to crush
the cables.
2. Raise the steering column and
insert the handlebars taking
care not to crush the cables.
3. Install the hook (see photo)
by approaching it to the rod,
making sure that it is aligned
with the holes, then insert the
screws.
4. Insert the screw on the outside
into the hole located under the
control panel.
5. Tighten the screws.
6. Put near and align the plastic
plate (see photo)
Insert the 4 screws manually without
tightening them, then use the hex
wrench supplied to tighten them and
secure the handlebars.