WAGNER FineCoat 9700 Manual De Instrucciones página 21

FineCoat 9700
2
EXPLANATORY DIAGRAM (FIG. 1)
POS. DESIGNATION
1 Spray gun complete
2 Spray jet width adjustment
3 Air cap (to set the working direction)
4 Ventilating hose
5 Valve
6 Container seal
7 Suction tube
8 Container
9 Trigger
10 Material volume regulation
11 Air volume control
12 Air hose
13 Carry handle
14 ON/OFF switch (I = ON, 0 = OFF)
3
CHOOSING THE SPRAY NOZZLE SET
Your HVLP paint spray gun must be equipped
with the spray nozzle set appropriate for the work
you are going to be carrying out. A spray nozzle
set comprises a needle (1), a spray nozzle (2) and
an air cap (3).
2
You should choose your spray nozzle set based on two criteria:
The type of material to be sprayed and the desired surface finish.
Using the table on the following page, it will be easy for you to
make the correct choice.
1
3
EXPLANATORY DIAGRAM/ CHOOSING THE SPRAY NOZZLE SET
POS. DESIGNATION
15 Air filter indicator ((lights up red if the main air filter is
blocked))
16 Air hose connection
17 Storage compartment for small parts / accessories
18 Gun mounting
19 Clamp for securing the coiled power cable
20 Power cable
21 Air filter cover (left and right)
22 Fastening strap for binding the rolled-up air hose to-
gether
23 Coarse feed tube filter (white)
24 Cleaning brushes (4 pcs.)
3.1 SWAPPING THE SPRAY NOZZLE SET
1. Remove the regulator ring (Fig. 2, 4), the air cap (3) and the
spring plate (5).
2. Remove the spray nozzle. (Fig. 3)
3. Remove the material regulator knob (Fig. 4, 6) and spring
(7).
4. Remove the needle (Fig. 5, 1).
If the needle does not slip out easily,
loosen the nut (Fig. 5, 8) to avoid the need-
le or seal being damaged.
5. The new spray nozzle set is assembled in the reverse
order.
EN
15