Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL INFORMATION FOR THE
INSTALLER
Installation, adjustments of controls and
maintenance must only be carried out by a
qualified engineer.
Incorrect installation may cause damage to
persons, animals or property for which the
Manufacturer shall not be considered
responsible.
During the life of the system, the automatic
safety or regulating devices on the appliance
may only be modified by the manufacturer or
by his duly authorized dealer.
4) INSTALLING GAS HOB
Check that the appliance is in a good condition
after having removed the outer packaging and
internal wrappings from around the various loose
parts. In case of doubt, do not use the appliance
and contact qualified personnel.
Never
leave
(cardboard, bags, polystyrene foam, nails, etc.)
within children's reach since they could
become potential sources of danger.
The measurements of the opening made in the top
of the modular cabinet and into which the hot plate
will be installed are indicated in either fig. 8.
Always comply with the measurements given for
the hole into which the appliance will be recessed
(see fig.9).
The appliance belongs to class 3 and is
therefore
subject
established by the provisions governing such
appliances.
BPE3411XM - BPE3411WM - BPE3411BM - BPE3410X - BPE3410W - BPE3410B
FIG. 8
30
INSTALLATION
the
packaging
to
all
the
provisions
FIG. 9
5) FIXING GAS HOB
The hot plate has a special seal which prevents
liquid from getting into the cabinet. Strictly comply
with the following instructions in order to correctly
apply this seal:
- Detach the seals from their backing, checking
that the transparent protection still adheres to the
seal itself.
- Overturn the hot plate and correctly position seal
"E" (fig. 10) under the edge of the hot plate itself,
so that the outer side of the seal perfectly
matches the outer edge of the hot plate. The
ends of the strips must fit together without
overlapping.
- Evenly and securely fix the seal to the hot plate,
pressing into place with the fingers and remove
the strip of protective paper from the seal and set
the plate into the hole made in the cabinet.
- The prospective walls (left or right) that exceed
the working table in height must be at a minimum
materials
distance from the cutting as mentionned both in
the columns and the scheme.
- In order to avoid accidental touch with the
overheating bottom of the hob, during the
working, is necessary to put a wooden insert,
fixed by screws, at a minimum distance of 50mm
from the top (see fig. 8)
COMPLY WITH THE
4F
FIG. 10
DIMENSIONS
A
B
C
553
473
65
D
E
62
65 min.
FIG. 11
Publicidad
