Stereo Sound Mode; Virtual Surround - Emerson LD195EMX Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Stereo Sound Mode

Stereo Sound Mode
CD
This unit allows you to select a sound mode during CD playback.
During playback, press [AUDIO ] repeatedly until the
desired sound mode appears.
Each time you press [AUDIO ], the sound mode
changes as example below.
STEREO (stereo sound with left and
L-ch
R-ch
Note:
Virtual surround cannot be changed when the sound mode
is set to either "L-ch" or "R-ch".

Virtual Surround

Virtual Surround
You can enjoy virtual surround on your 2 channel stereo system.
1
During playback, press [MODE] repeatedly until "
appears.
2
Press [Cursor K / L] to select the sound level.
or
1 :
Natural effect.
2 :
Emphasized effect.
OFF : No effects (original sound).
3
Press [BACK
] to exit.
Note:
The setting will be kept even if the unit is turned off.
For audio CD, virtual surround will not be effective if the
sound mode is set to something other than "STEREO".
(Refer to "Stereo Sound Mode" on page 43.)
Turn down the level or select "OFF" if the sound is distorted.
STEREO
right channels)
(left channel sound only)
(right channel sound only)
OFF ( SURROUND )
( SURROUND )
1
Español
Marker Setup
Marker Setup
This feature allows you to assign a specific point on a disc to be called back later.
To set a marker
1
During playback, press [MODE] repeatedly until
"
" / "
" appears.
2
Use [Cursor K / L ] repeatedly until marker search menu
appears.
or
3
Use [Cursor s / B] to select an available marker within
60 seconds.
or
4
When the playback reaches the point at which you
want to set a marker, press [ENTER].
Marker is now set.
"
5
Press [BACK
] to exit.
To return to the marker later
1
Repeat steps 1-2 in "To set a marker". Use [Cursor s / B]
to select the desired marker.
or
2
Press [ENTER] at the desired marker to restart playback
from the specific point which you set.
Note:
Marker search menu will disappear in about 60 seconds
when there is no input.
You can mark up to 10 points.
To clear a marker, select the marker to be cleared, and then
press [CLEAR].
Ejecting the disc or turning off the power will erase all
markers.
Selecting "
" at step 3 in the section "To set a marker" will
also erase all markers.
Français
English
e.g.) DVD
_ _ /12 (SEARCH)
1 2 3 4 5 6 7 8 9 10 AC
1 2 3 4 5 6 7 8 9 10 AC
2 3 4 5 6 7 8 9 10 AC
e.g.) DVD
2 3 4 5 6 7 8 9 10 AC
2 3 4 5 6 7 8 9 10 AC
43
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido