Lionelo Braam i-Size Manual De Usuario página 18

NOTE! The support leg must never hang in the air and no objects may be placed under it.
8.
Press the seat rotation button (19, fig. B) and then move the seat to a lateral position,
at an angle of 90° (fig. 7).
9.
Loosen the shoulder belts of the seat by pressing the belt adjustment button (fig. 8)
Use the belt retaining magnets for easy insertion of your child into the seat.
10. Place the child in the seat.
11. Connect the belt connectors and then insert them into the buckle (fig. 10). You will
hear a characteristic click.
12. Pull the strap to tighten the belts (fig. 14). To loosen the belts, press the belt adjustment
button and pull on the shoulder belts (fig. 8).
13. Adjust the headrest (see: Headrest adjustment).
14. Press the seat rotation button (19, fig. B) and then move the seat to the forward facing
position. Use the tilt adjustment button to adjust the seat to the desired position.
15. To release the 5-point seat belts, press the red button on the buckle (fig. 9).
FORWARD FACING (100 – 150 CM)
1.
Fold the stabilisation leg (see: Seat removal – stabilisation leg).
2.
Remove the seat belts (see: Seat belt removal).
3.
Press the seat rotation button (19, fig. B) and then move the seat to the forward facing
position. The correct positioning will be signalled by a click.
4.
Place the seat on the sofa of the car in the space provided for installation.
Note! If installing without ISOFIX system, skip step number 5.
5.
Push in the ISOFIX sliding lever on both sides and extend the ISOFIX arms (fig. 3).
Anchor the ISOFIX arms to the anchorages located in the car's sofa (fig. 4). The arms
will interlock and you will hear the characteristic click. The green indicator on the ISOFIX
button must be visible on both sides of the seat (fig. 4).
6.
Ensure that the anti-rotation frame is pressed firmly against the backrest of the sofa in
the car (fig. 5). Push the base using a left-right movement towards the back of the vehicle
seat until it is completely aligned with the back of the anti-rotation frame.
7.
Place the child in the seat (fig. 28) and adjust the headrest (see: Headrest adjustment).
8.
Pass the shoulder belt through the shoulder belt guide, which is located in the headrest
of the seat. Pass the lap belt through the lap belt guide (fig. 29a).
9.
Fasten the seat belts. Make sure the belts are not twisted (fig. 29b).
10. Make sure that the belts are correctly positioned in the guides (fig. 29c).
EN ‑ 18 ‑