Lionelo Bastiaan i-Size Manual De Usuario página 13

(fig. 1). Try to move the seat, properly anchored will not allow you to change position.
4.
Adjust the tilt of the backrest to the semi-reclining position (position "1"), (see: Seat
tilt adjustment).
5.
Press the seat against the backrest of the car's bench seat. Push the base using a left-
right motion toward the backrest to make sure it is pressed as tightly as possible
against the car's bench seat.
6.
The green indicator on the ISOFIX button must be visible on both sides (fig. 3).
7.
Unbuckle the Top Tether belt, and then slide the buckle and hook (18, fig. B) to the
end of the unbuckled belt (fig. 5).
8.
Guide the belt through the Top Tether belt guide, located at the top of the seat
backrest (fig. 6).
9.
Attach the Top Tether belt to the anchor points in the car. Anchor points can be in
different locations depending on the vehicle (fig. 7a).
10. Tighten the Top Tether belt and make sure the indicator is green (fig. 8). The seat is
now properly installed in the car.
NOTE! When installing a rear-facing car seat, to maintain the functionality of the rotation
system and not block it, route the Top Tether belt on the inside of the car.
11. Press the seat rotation button (13, fig. B), then move the seat to a lateral position,
at a 90° angle. The correct setting will signal a click.
12. Place the child in the seat and adjust the headrest (see: Headrest adjustment).
13. Fasten the seat belts (see: Fastening and unfastening the child in the seat).
14. Press the seat rotation button (13, fig. B), then move the seat to the rear-facing
position. Try to move the seat, properly anchored will not allow you to change position.
FORWARD FACING (76 – 105 CM)
1.
Place the seat on the car's bench seat in the space provided for installation.
2.
Push in the ISOFIX sliding lever and extend the ISOFIX arms (fig. 2). Anchor the ISOFIX
arms to the attachments located in the car's bench seat. The arms will interlock and
you will hear a characteristic click (fig. 3). If necessary, use the plastic guides included
in the set to make installation easier (fig. 4).
3.
Press the seat rotation button (13, fig. B), then move the seat to the forward-facing
position (fig. 1). Try to move the seat, properly anchored will not allow you to change
position.
4.
Set the seat tilt to one of the 4 available positions (see: Seat tilt adjustment).
5.
Press the seat against the backrest of the car's bench seat. Push the base using a left-
‑ 13 ‑ EN