1.
While holding the seat belt tension adjustment button, loosen the belts (fig. 12).
2.
Pull the headrest adjustment lever and raise the headrest (fig. 21).
3.
Unzip the cover at the back of the seat (fig. 22).
4.
Remove the belt loops from the metal connection plate (fig. 23) and the headrest
lever (fig. 24).
5.
Put the upper part of the shoulder belts through the corresponding holes in the
seat back (fig. 25).
6.
Unfasten the seat belts (see: Fastening and unfastening seat belts).
7.
Remove the seat belt buckle from the protective cushion. Then put the metal end
of the belt through the corresponding hole in the seat and remove the belt (fig. 26).
8.
Place the removed seat belt components in the pocket located on the inside of the
cover (fig. 27).
To reinstall the belts, follow the above steps in reverse order.
REMOVAL OF THE SEAT – ISOFIX
To detach the ISOFIX arms, push in the ISOFIX sliding levers on both sides. The indicator
on the ISOFIX button will turn red.
REMOVAL OF THE SEAT – TOP TETHER
Unfasten the Top Tether belt from the anchor points in the car. Loosen the belt. The
indicator will turn red.
SEAT TILT ADJUSTMENT
To adjust the seat tilt, press the tilt adjustment lever (8, fig. B) and move the seat to the
desired position.
The seat has 4 levels of tilt adjustment in the forward-facing position (fig. 20). In the rear-
facing position, place the seat in the semi-reclining position (position "1").
SEAT ROTATION
Press the seat rotation button (13, fig. B), then adjust the seat to the rearward or forward
facing position. Try to move the seat, properly anchored will not allow you to change position.
REMOVING AND ATTACHING THE COVER
Unzip the cover and slide it completely off the seat body. To do this:
1.
Adjust the headrest to the highest available position (see: Headrest adjustment).
EN
‑ 16 ‑