Publicidad
INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ / SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA / SICHERHEITSHINWEISE /
VEILIGHEIDSINSTURCTIES / INSTRUZIONI DI SICUREZZA / ΟΔΗΓΊΕΣ ΑΣΦΑΛΕΊΑΣ / ИНСТРУКЦИИ ПО ТЕХНИКЕ БЕЗОПАСНОСТИ
IMPORTANT NOTES
FAN CONTROL
Your warranty will be void if a solid-state dimmer type fan controller or other band wall controller is used. ONLY use the wall
controller supplied.
With these controllers there is a strong possibility that the ceiling fan motor will produce an unpleasant load humming noise.
FAN INSTALLATION
Under the warranty terms, this ceiling fan must be installed by a licensed electrician. Improperly installed ceiling fans can be
dangerous and expensive to repair. This voids warranty too. This fan is designed for indoor use only, mounting where the fan is
subject to water or moisture can be dangerous and also void the warranty.
FAULT FINDER
Always check the "Trouble Shooting Checklist" included in this booklet before calling for service. Unnecessary calls are
inconvenient for all and can attract a service charge.
MECHANICAL NOISE MAY BE NOTICED ON INSTALLATION-ALLOW AT LEAST 8 HOURS SETTLING-IN PERIOD. SOME
FANS WOBBLE MORE THAN OTHERS—EVEN IN THE SAME MODEL; IT DOES NOT MEAN THE FAN IS FAULTY.
WARNING
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
The fan must be installed so that the blades are at least 2.1 meters above the floor.
The important safeguards and instruction appearing in this manual are not meant to cover all possible conditions and situation that
may occur. It must be understood that common sense, caution and care are factors, which cannot be built into any product. These
factors must be supplied by the person(s) caring for and operating the unit.
BEFORE INSTALLATION
Unpack your ceiling fan carefully. Remove all parts and hardware. Place fan motor on a cloth or soft surface to avoid damaging the
finish.
Verify that all parts are present before starting assembly. And check the packaging carefully for missing parts.
Examine all parts. You should have the following:
INSTALLATION INSTRUCTIONS
FAN ASSEMBLY
- Phillips head screw driver
- Flat head screw driver
- Pair of pliers
- Adjustable Spanner
- Step ladder
- Wire cutter
- Wiring, supply cable as required by AS/NZS
3000 wiring code.
eco indus ref. 33005
1. Wall plugs for bracket screws x 2
2. Canopy screw x 4
3. Hanger Bracket x 1
4. Screw for Hanger bracket x 2
5. Extra blade screws and washer x 1 set
6. Blade with Blade holder x 3
7. Pre-assembled Fan Motor, down rod and canopy x 1
8. Decorative Cover x 1
9. Wall controller x 1
faro 16
Publicidad
