Publicidad
INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ / SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA / SICHERHEITSHINWEISE /
VEILIGHEIDSINSTURCTIES / INSTRUZIONI DI SICUREZZA / ΟΔΗΓΊΕΣ ΑΣΦΑΛΕΊΑΣ / ИНСТРУКЦИИ ПО ТЕХНИКЕ БЕЗОПАСНОСТИ
You may do the following action to reduce the wobbling
1) Check all the blade mounting screws are tightened and securely.
2) Wobbling problems may result from inconsistent blade level. To check
blade level, measure the distance from each blade tip to
the ceiling.
Note: If measurements are inconsistent: check blade mount screw are not
over tighten or loose which can cause the blade tip not to be all leveled;
If measurements are still inconsistent, adjustments of the bracket will be
required, by bending the inconsistent metal blade carefully so that it is
leveled with the other blades.
Blade tracking may be checked simply by use of a household yardstick as
shown in Figure 10. Place the yardstick vertically against the ceiling and
even with the outside leading edge of a blade. Note the distance of the
edge of a blade is the same as others. Turn the blade slowly by hand to
check the remaining blades. If a blade is not in alignment, the blade is
either out of shape / warped or the blade screws are not evenly tightened or
are loose.
FAN CARE AND WARRANTY INFORMATION
CARE & CLEANING
Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free cloth to avoid scratching the paint
finish. Please turn off electricity power when you do so.
Do not use water when cleaning your ceiling fan. It could damage the motor or the wooden blades and create the possibility of an
electrical shock.
The motor has permanently lubricated ball bearing. No need to oil
WARRANTY SERVICE
The manufacturer warranty covers actual faults that may develop, but NOT minor complaints, e.g. noise from motor run—ALL
ELECTRIC MOTORS ARE AUDIBLE TO SOME EXTENT.
WOBBLE
Ceiling fans tend to move during operation due to the fact that they are not generally rigidly mounted—if they were, they could
generate excessive ceiling vibration and stress on their mountings.
Movement of a couple of centimetres is quite acceptable and does not suggest the fan will fall down.
Ceiling fans are mounted very securely on steel brackets with rubber cushioning or with ball-joints to allow free movement.
Please note that all ceiling fans are not the same, even in the same model—some may move more or less than others.
NORMAL WEAR AND TEAR
Threaded components that are slightly loose or blade carriers that have slightly bent due to vigorous cleaning or bumping can
cause extra wobble and noise. THIS IS NOT COVERED UNDER WARRANTYbut a little care and maintenance can reduce or
prevent this problem.
BUMP-IN-THE NIGHT
This is the biggest cause for service calls, which are outside the manufacturer's warranty. If a fan has a fault, it will be noticeable at
all times. Naturally, when everything is quiet at night, you will be more inclined to hear small noises, which may not be noticeable at
other times. Even slightly power fluctuations, and mains frequency signals superimposed in your electricity supply for off-peak hot
water control may cause a change in fan motor noise. This is normal.
WARNING
The fan must be installed so that the blades are more than 2.1 meters above the floor.
According to law in Australia, all electrical connections must be installed by a licensed electrician.
This ceiling fan is within this requirement
According to our warranty terms, only the fans installed by licensed electrician get warranty service covered.
NOTES TO INSTALLERS
All electric motors, including fans make some noise and may feel hot if touched—this is not a fault.
Some fan wobble more than other—even in the same model.
Fan lights can rattle, but are not covered under warranty
Fan wall controller make slight buzz and get warm especially on lower setting.
These occurrences are not covered by the manufacturer's warranty.
eco indus ref. 33005
faro 20
Publicidad
