IPC 1450 E Manual De Instrucciones página 50

Always monitor the hydraulic oil level. It must be at the correct level to avoid
6.2.1. "PETROL / DIESEL" version
Read the engine instruction manual annexed to the machine manual carefully and check
the level of oil in the engine. If low, top up wearing protective gloves.
Check the hydraulic oil level (AGIP ARNICA 68 type), if low, top up wearing protective
gloves.
Fill up with fuel (fig. B, ref. 4).
Mount the side brushes (see MAINTENANCE chapter).
6.2.2. "BATTERY" version
Check the acid level and charge of the batteries. To top up and charge the batteries see
the chapter HANDLING AND INSTALLATION.
Check the hydraulic oil level (AGIP ARNICA 46 type), if low, top up wearing protective
gloves.
Mount the side brushes (see MAINTENANCE chapter).
If you are using the machine for the first time, we recommend trying it on a large
obstacle-free surface first to acquire the necessary familiarity.
6.3. Working
Starting up/use:
The seat (fig. A, ref. 4) is fitted with a safety sensor which enables operation of the
machine only when the operator is seated.
•
Prepare the machine as described above.
•
(PETROL and DIESEL version) set the accelerator handle (fig. D, ref 1) to minimum.
•
(PETROL and DIESEL version) turn the ignition key (fig. C, ref. 1), then release
when the engine has started. Check that all the multifunction lights are off except for
the OK light (fig. C, ref. 12) .
•
(PETROL and DIESEL version) accelerate to maximum using the handle (fig. D, ref.
1) .
•
(BATTERY version) turn the ignition key (fig. C, ref. 1), to position 1
In the BATTERY version, when you turn the ignition key to position 1 (fig. C, ref. 1),
only the electric motor running the drive pump comes on. The electric motor
running the pump which drives the functions (centre brush feed and bin raising)
comes on when you press the button/switch turning on the functions on the
control panel.
•
Move the machine to the work area, keeping your hands on the steering wheel and
pressing the machine movement pedal (fig. A, ref. 3). Pressing it forwards moves the
machine forwards, pressing the back moves the machine backwards.
•
Make sure the debris bin is perfectly closed, otherwise close it using the control panel.
Opening of the debris bin disables operation of the suction fan and centre brush.
WARNING
overheating.
i INFORMATION
i INFORMATION
i INFORMATION
i INFORMATION
ENGLISH
11