Pre-Installation (continued)
PACKAGE CONTENTS
Part
A
B
C
D
MOUNTING LOCATIONS
Determine the mounting location – a wall or under
an eave.
Position the bulb holders (A) in the general
direction of the desired light coverage and tighten
the lock nuts (1) and the thumb screws (2).
If needed, lift the motion sensor (C) up and
rotate it so the controls face the ground after
installation. Tighten the clamp screw (3) when
done. Do not overtighten.
NOTE: If the motion sensor (C) pops out of the ball joint,
loosen the clamp screw (3), push the motion sensor (C)
back into the ball joint, and tighten the clamp screw (3). Do
not overtighten.
A
D
C
Description
Bulb holder
Canopy
Motion sensor
Shell
B
Wall Mount
A
2
1
1
3
5
Please contact 1-866-308-3976 for further assistance.
A
D
Quantity
2
1
1
2
2
Eave Mount
C
HOMEDEPOT.com