SOMFY TILT&LIFT 25 WF ZIGBEE Manual De Instrucciones página 4

EN
2.1.Assembly
2.1.1.Preparing the drive
1] Cut the shaft to the length required.
2] Position the headrail and shaft adapters on the drive.
2.1.2.Drive integration inside the headrail
1] Insert the drive in the headrail.
CAUTION
Take care not to cut the power supply cable on the edges of the headrail when
introducing the drive.
2] Let the shaft abut against the drive shaft adapters.
NOTICE
For optimal radio reception, the drive antenna should be kept straight and
should be positioned outside of headrail (if used).
2.1.3.Drive and shaft locking
1] Using the relevant tool, pinch headrail edges to block drive translation.
2] To lock the shaft, place stop rings against the CTS, and screw them.
4
1]
2]
1]
2]
©
Copyright 2023 SOMFY ACTIVITES SA. All rights reserved.
TILT&LIFT 25 WF ZIGBEE
1] 2]