SOMFY TILT&LIFT 25 WF ZIGBEE Manual De Instrucciones página 7

Idiomas disponibles

TILT&LIFT 25 WF ZIGBEE

1] Plug in the power supply of the drive.

g If the drive is not set or paired, once plugged in, it goes into programming

mode during 3 min, and its LED blinks orange.

NOTICE

If the drive has left the programming mode, its LED is not blinking:

• Press and hold the PROG button on the drive until the motorised product

moves up and down briefly and its LED blinks orange : the drive is in

programming mode during 3 min.

2] Bring the control point close to the drive then briefly press simultaneously

the Up and Down buttons on the control point: the control point looks for

the closest drive in programming mode.

g When found, the feedback LED on the control point blinks in green, the

drive LED flashes in green, and the motorised product moves up and

down briefly.

g Then the feedback LED on the control point blinks in orange slowly as

long as it is in setting mode.

NOTICE

If the control point does not find a drive nearby, the feedback LED of the control point blinks red after a few seconds,

and the motorised product of the drive does not move: repeat the above procedure. (If the drive is still in

programming mode, repeat only step 2).

NOTICE

If the control point does not find the right drive, please refer to chapter Scanning mode.

2.5.2.Scanning mode

If several drives are in programming mode, it is possible to be in setting mode with an

undesired drive.

1] Make sure the drive to be paired is still in programming mode. Otherwise,

restart from the beginning of commissioning steps.

2] If the drive to be paired is still in programming mode, bring the control point

close to the drive then briefly press the Up and Down buttons on the

control point simultaneously to exit the setting mode with the previous drive

and scan another close Zigbee drive.

g The motorised product of the new found drive moves up and down

briefly, the drive is in setting mode.

...