Publicidad
Idiomas disponibles
Idiomas disponibles
3.2.13 W
. Maintenance and/or repair of electrical components MUST be carried
arning
out by qualified staff.
3.2.14 W
. DISCHARGE residual pressure before disconnecting the hose from the
arning
machine.
3.2.15 W
. CHECK before each use and at regular intervals that the screws are fully
arning
tightened and that there are no broken or worn parts.
3.2.16 W
. ONLY USE detergents which will not corrode the coating materials of
arning
the high pressure hose / power cable.
3.2.17 W
. KEEP people or animals at least 15 m away.
arning
3.2.18 W
. This machine is designed for use with the detergents supplied or
arning
recommended by the manufacturer. The use of other detergents or chemicals
may adversely affect the machine' s safety.
3.2.19 W
. Do not allow the detergent to come into contact with the skin, and the
arning
eyes in particular! In case of contact with eyes, rinse with plenty of water and
seek medical advice at once!
3.2.20 W
. High pressure hoses, fittings and joints are important for the machine' s
arning
safety. Use only high pressure hoses, fittings and joints recommended by the
manufacturer.
3.2.21 W
. To ensure the machine' s safety, only use the manufacturer' s genuine
arning
parts, or other parts which carry its approval.
3.2.22 W
. If an extension cable is used, the plug and socket must be watertight.
arning
3.2.23 W
. Unsuitable extension cables can be dangerous. If an extension cable is
arning
used, it must be suitable for outdoor use, and the connection must be kept dry
and off the ground. Use of a power cable reel which keeps the socket at least
60 mm above the ground is strongly recommended.
3.2.24 W
. Switch the machine off and disconnect it from the power supply before
arning
assembly, cleaning, adjustments, maintenance, storage and transportation.
3.2.25 W
. Insert the drain pipe cleaning kit down to the red mark before turning
arning
the machine on.
3.2.26 W
. DO NOT to exceed the maximum electrical permissible system
arning
impedance at the connection point (see "Technical Data" chart).
Contact the electricity provider in case of further clarifications about the
permissible system impedance.
English
11
Publicidad
