Dräger UCF FireCore Instrucciones De Uso página 19

3.3 Meaning of the LEDs
LEDs on the thermal imaging camera
LED
LED 1 flashes green
(2 Hz)
LED 1 lights green
LED 2 lights green
LED 2 lights yellow
LED 2 lights red
LED 3 slowly flashes
blue (2 Hz)
LED 3 lights blue
LEDs 1 and 2 rapidly
flash red (4 Hz)
LEDs 1 and 2 light red
LEDs on the charging cradle
There are 4 LEDs on the charging cradle which indicate the status of the
charging process.
LED
LED 1 lights green
All 4 LEDs light green
LEDs 1, 2 and 3 light
green; LED 4 flashes
green (1 Hz)
LEDs 1 and 2 light green;
LED 3 flashes green
(1 Hz)
LED 1 lights green;
LED 2 flashes green
(1 Hz)
All 4 LEDs slowly flash-
ing yellow (2 Hz)
Dräger UCF FireCore
Meaning
Self-test during the start sequence
The thermal imaging camera is switched on.
The battery charge is 51% to 100%.
The battery charge is 26% to 50%.
The battery charge is less than 25%, but is sufficient
for a further 5 minutes
Not paired
Pairing with another device is established
Overheating of the thermal imaging camera
– Error in the thermal imaging camera
– System fault
Meaning
The charging cradle is ready for operation.
The battery is fully charged.
Battery is 75% to 99% charged.
Battery is 50% to 74% charged.
Battery is 25% to 49% charged.
– Charging process interrupted
– Battery temperature outside permitted range
– Battery can no longer be charged
|
Description en
19