Descargar Imprimir esta página

Dräger UCF FireCore Instrucciones De Uso página 22

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 43
en
|
Use
4.2 Preparations before first use
4.2.1 Fitting the Smart Adapter to the helmet
● See the associated assembly instructions
4.2.2 Fitting the charging cradle(s)
Prerequisites
Only use the charging cradles indoors.
Fit the charging cradles a maximum of 2 metres above the floor.
For mounting, 4 screws are needed per charging cradle.
Up to 5 charging cradles can be connected together.
1. If required, link the charging cradles together (see Figure C on the fold-out
page)
a. Remove the covers (1, 3).
b. Plug the link (4) into the charging cradle.
c. Plug the link (4) from one charging cradle into the opening in the next
charging cradle.
d. Lock the locking screw on the upper side of the charging cradle and join
two charging cradles with a locking clip (5).
2. Plug the power supply unit or the vehicle adapter (2) into the charging
cradle.
3. If necessary, pre-drill holes and fasten the charging cradles with the screws.
4. Connect the plug-in power supply unit or the vehicle adapter to the power
supply.
4.3
Preparations before each use
1. Fully charge the rechargeable battery in the thermal imaging camera (the
LEDs on the charging cradle will then light green).
2. Visually inspect the thermal imaging camera: There must be no damage
present.
3. Pairing the thermal imaging camera with the In-Mask Display
(see also Figure B on the fold-out page)
a. Switch on the thermal imaging camera (1) and the In-Mask Display (2).
To do this, press both On/Off buttons for approx. 2 seconds. The startup
screen is shown on the In-Mask Display.
22
Dräger UCF FireCore

Publicidad

loading

Este manual también es adecuado para:

3716690