Mityvac MV7201 Instrucciones De Uso Y Mantenimiento página 4

 Once oil is extracted from crankcase,
remove expandable rubber plug from
reservoir tank.
 Pour oil from tank into suitable
container, and dispose of oil in
appropriate manner.
 Rinse out reservoir tank with clean
solvent or engine degreaser. Allow to dry
thoroughly.
 If using fluid evacuator plus to dispense
oil, fill cleaned reservoir tank with new oil
and switch selector valve mounted on
side of pump assembly to dispense.
 Pull up on pump handle and begin
pumping until engine crankcase is filled
to desired level.
 Run engine momentarily to circulate
new oil and then re-check level.
Extract from and
dispense fluid into
transmission cases
and differentials
 Follow steps  and  above in Extract and
dispense motor oil into a crankcase.
 Remove transmission fluid dipstick or
fill plug.
 Select and insert appropriate
diameter dipstick tube into dipstick fill
hole until it reaches bottom of
transmission pan or gear case.
WARNING

In some applications this may require jacking
or lifting vehicle. Use appropriate safety
stands to avoid serious or fatal injury.
 Connect main suction tube to
dipstick tube.
 Insert opposite end of main
suction tube into mm x ° tube
connector on top of reservoir tank.
NOTE
Verify tube is in connector all the way to
prevent leakage.

 Place selector valve mounted on side of
pump assembly to evacuate.
 Raise pump handle on reservoir tank
until highest limit is reached. Pump
handle approximately ten times. Unit will
begin to extract transmission fluid from
transmission.
 Once transmission fluid has been
extracted, remove expandable
rubber plug from reservoir tank.
 Pour transmission fluid from tank into
suitable container, and dispose of
transmission fluid in an
appropriate manner.
 Rinse out reservoir tank with clean
solvent or engine degreaser. Allow to dry
thoroughly.
 If using fluid evacuator plus to dispense
transmission fluid, fill cleaned reservoir
tank with new transmission fluid and
simply switch selector valve mounted on
the side of pump assembly to dispense.
 Pull up on pump handle and continue
pumping until the transmission is filled
to the desired level.
 Follow operating instructions for vehicle
to properly check transmission fluid level.