Bimar LD-568 Folleto De Instrucciones página 12

Fax +32 030 9904733

Pos.A
Position lighting
CLEANING AND MAINTENANCE
Attention: before cleaning the appliance, turn it off and wait for it to cool down completely.
To clean the outside of the heater, use a soft cloth soaked with water and a liquid detergent. Do not
use scouring pads or abrasive products.
Do not use water, inflammable or abrasive cleaners.
• Regularly inspect the atmosphere analyzer and the aeration holes; if there is dust or lint, remove it
without damaging the burner or tubing.
• Regularly check the condition of the flexible rubber tube and replace it by the expiration date
stamped on it; check the condition of the gasket seal on the pressure regulator every time the gas
cylinder is changed.
• Take care not to hit or damage the surface of the burner (it's delicate), the fittings and gas tubes, the
tap and all the other components of the gas circuit.
• We recommend to let the heater inspected once a year by one of our authorized service centers.
• If you decide not to use the heater for an extended period, it is a good idea to follow the
instructions below:
1) Close the tap on the cylinder and disconnect the pressure regulator from the cylinder.
2) Store the cylinder in a well-ventilated room, far from inflammable or explosive materials and
preferably outside your home; never store the cylinder in a basement or attic, garage, and storage
closet. Give back to the seller the empy gas cylinder. Never leave the empty cylinder among
garbage. Never recharge the cylinder alone as it could be very dangerous. Only authorized seller
can safely recharge the cylinder with LPG.
3) The heater must be stored in a dry place and protected from dust (and even better in its original
packaging).
• If you decide not to use the appliance any more, we recommend to disconnect the cylinder
following the above instructions for storage; to make it inoperable by cutting the flexible rubber
tube and to make harmless those parts that could be dangerous for children.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT.
At the end of its working life, the product must not be disposed of as urban waste. It can be taken to a
special local centre for waste collection and recycling or to a dealer providing this service. Disposing
of a household appliance separately avoids possible negative consequences for the environment and
health deriving from inappropriate disposal and enables the constituent materials to be recovered to
obtain significant savings in energy and resources. As a reminder of the need to dispose household
appliances separately, the product is marked with a crossed-out wheeled dustbin. The uncorrected
disposal of the appliance by the user implies administrative fines according to the existing laws.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
Pos.1 Pos.2
Position Minium Position
medium
12
Assembly page 12/32
Pos.3
Position
maximum
32
/
Pos.OFF
Position Off