Aqara T1 Manual De Instrucciones página 6

Manufacturer: Lumi United Technology Co., Ltd.
Address: Room 801-804, Building 1, Chongwen Park, Nanshan iPark, No. 3370, Liuxian Avenue,
Fuguang Community, Taoyuan Residential District, Nanshan District, Shenzhen, China
Online Customer Service: www.aqara.com/support
Email: support@aqara.com
Note:
1. This product may be extended up to for 10 m;
2. The device shall not be installed in water or inflammable, explosive, high-temperature or high-hu-
midity environment or a location directly exposed to the sunlight. The installation environment
must be ventilated properly;
3. During the installation and use, do not damage the structure of the product. Do not beat or strike it
with a heavy object, nor bind the Strip with metal wires tightly. Otherwise, the wires may be
embedded in the Strip and cause a short-circuit fault, burning the Strip;
4. During the operation of the Strip, do not wrap or cover it with any object;
5. Avoid contact with any acidic, alkaline, or other chemicals;
6. This product needs to be adapted to SELV power of 24 VDC, 1.5 A;
7. Strip cutting needs to be in the marked part. The cut Strip cannot continue to be used. Please cut
when it is powered off.
8. The external flexible cord of this luminaire cannot be replaced, if the cord is damaged, the luminaire
shall be destroyed.
9. The light source of this luminaire is not replaceable, when the light source reaches its end of life the
whole luminaire shall be replaced
10. Under normal use of conditions, this equipment should be kept a separation distance of at least
20cm between the antenna and the body of the user.
EU Declaration of Conformity
Hereby, [Lumi United Technology Co., Ltd] declares that the radio equipment type [LED Strip T1,
LEDS-K01/ RLS-K01D/LEDS-K02/RLS-K02D] is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address: https://www.aqara.com/DoC/
04