Publicidad
Step 6
Fasten the VERTICAL MOLDINGS (M) to the END MOLDINGS (L).
å
Use six SILVER 1-1/8" FLAT HEAD SCREWS (10S).
NOTE: Be sure the HALF DISK is against the PLINTH (T) before
å
tightening any screw. The screws should tighten into the groove of
the VERTICAL MOLDING. Do not overtighten.
T
Page 10
T
L
M
SILVER 1-1/8" FLAT HEAD SCREW
(6 used in this step)
L
416515
10S
M
www.sauder.com/services
Publicidad
