Publicidad
Step 14
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting
å
screw is against the stops as shown in the right diagram. If it isn't,
loosen the mounting screw to slide it against the stops. Then
tighten the mounting screw.
Fasten a DOOR (G) to the LEFT END (B) as shown in the lower
å
diagram. Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
Fasten a KNOB (42K) to the DOOR (G). Use a GOLD 1" MACHINE
å
SCREW (50S).
Repeat this step for the other door.
å
See the next step for DOOR adjustments.
å
GOLD 1" MACHINE SCREW
(2 used in this step)
Page 18
42K
50S
B
G
416515
Stop
Mounting
screw
Hinge
www.sauder.com/services
Publicidad
