Descargar Imprimir esta página

Johnson JINDU329 Manual De Instrucciones página 43

Placa de inducción

Publicidad

Idiomas disponibles

Idiomas disponibles

Pans do not become hot
and appears in the
display.
The induction hob or a
cooking zone has turned
itself off
unexpectedly, a tone
sounds and an error
code is displayed
(typically alternating
with one or two digits in
the cooking timer
display).
8. Failure Display and Inspection
The induction hob is equipped with a self diagnostic function. With this test the technician is able to check
the function of several components without disassembling or dismounting the hob from the working
surface.
Troubleshooting
1) Failure code occur during customer using & Solution;
Failure code
Ceramic plate temperature sensor
E1
failure--open circuit.
Ceramic plate temperature sensor failure-
E2
-short circuit.
Eb
Ceramic plate temperature sensor failure
E3
High temperature of ceramic plate sensor.
Temperature sensor of the IGBT failure
E4
--open circuit.
Temperature sensor of the IGBT failure
E5
--short circuit
E6
High temperature of IGBT.
The induction hob cannot
detect the pan because it is not
suitable for induction cooking.
The induction hob cannot detect
the pan because it is too small for
the cooking zone or not properly
centred on it.
Technical fault.
Problem
No Auto-Recovery
Use cookware suitable for induction
cooking. See section 'Choosing the right
cookware'.
Centre the pan and make sure that its
base matches the size of the cooking
zone.
Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.
Check the connection or replace the
ceramic plate temperature sensor.
Wait for the temperature of ceramic plate
return to normal.
Touch "ON/OFF" button to restart unit.
Replace the power board.
Wait for the temperature of IGBT return to
normal.
Touch "ON/OFF" button to restart unit.
Check whether the fan runs smoothly;
if not , replace the fan.
18
Solution
V.1

Publicidad

loading