Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
First of all we would like to thank and congratulate you for the purchase of this product manufactured by
Golmar.
The commitment to reach the satisfaction of our customers is stated through the ISO-9001 certification
and for the manufacturing of products like this one.
Its advanced technology and exacting quality control will do that customers and users enjoy with the
legion of features this system offers. To obtain the maximum profit of these features and a properly wired
installation, we kindly recommend you to expend a few minutes of your time to read this manual.
INDEX
Introduction........................................97
Index .................................................97
Starting recommendations....................97
Safety precautions ...............................98
System characteristics .....................98-99
System operation.................................99
Door panel installation.............................
Description ....................................100
Embedding box positioning.......101-102
Door panel modules assembly ..........102
Electronic modules assembly ............103
Door panel fixing ............................104
Place informative window label .........104
Push buttons wiring ..................105-106
Push buttons coding ........................107
EL500SE configuration ...............108-109
Programming (general panel)....110-112
Informative window connection.........112
Lamps wiring ..................................113
Final adjustments ............................113
Power supply installation.....................114
Lock release installation .....................114
Platea/Tekna Plus monitor ........................
Description ....................................115
Function push buttons......................116
EL562 module................................117
STARTING RECOMMENDATIONS
O
Do not use excessive force when tightening the power supply connector screws.
O
The entire installation must be at least 40cm. away from any other installation.
O
Before to connect the system, check the connections between door panel, distributors, monitors,
telephones, and the transformer connection. Do always follow the enclosed information.
O
Each time the power supply is restarted, or after a modification, the system will remain blocked during
30 seconds.
O
Always use RG-59 B/U MIL C-17 or RG-11 coaxial cables, (see page 126). Never use coaxial
antenna cable. In installations no longers than 100m., Golmar RAP-5130 cable can be used.
97
End of line resistor ...........................117
Front film replacement .....................117
Monitor connector description ..........118
Monitor installation .........................119
Programming .................................120
T-740 Plus telephone ...............................
Description .............................121-122
Function push buttons......................122
Telephone installation......................123
Programming .................................124
Installation diagrams ...............................
Video installation with coaxial.......125-126
Video installation without coaxial ..127-128
Audio installation.......................129-130
Video installation (general panel) ..131-134
Audio installation (general panel) ..135-136
Connection of an a.c. lock release.....137
Link of several power supplies ...........137
Optional connections ...................138-142
Troubleshooting hints.........................143
Notes .......................................144-150
Compliance .....................................151
98
O
Install or modify the equipment without the power connected.
O
The installation and handling of these equipments must be performed by authorised personnel.
O
The entire installation must be at least 40 cm. away from any other installation.
O
With power supply:
wDo not use excessive force when tightening the connector screws.
w
Install the power supply in a dry and protected place without risk of drip or water projections.
w
Avoid to place it near to heating sources, in dusty locations or smoky enviroments.
w
Do not block ventilation holes of the unit so that air can circulate freely.
w
To avoid damage, the power supply has to be firmly fixed.
w
To avoid an electrical shock, neither remove the protection cover nor handle the connected wire in
the terminals.
O
With monitor, telephones and distributor:
w
Do not use excessive force when tightening the connector screws.
w
Install the power supply in a dry and protected place without risk of drip or water projections.
w
Avoid to place it near to heating sources, in dusty locations or smoky enviroments.
wDo not block ventilation holes of the equipments so that air can circulate freely.
O
Remember, the installation and handling of these equipments must be performed by authorized
personnel and in the absence of electrical current.
O
Do always follow the enclosed information.
O Microprocessed system with simplified installation:
wAudio door entry system with 4 common wires installation.
wVideo door entry system with 3 common wires plus coaxial cable installation.
wVideo door entry system with 4 common wires plus twisted pair installation.
O Microprocessed circuit EL500SE with two operating modes(EL500 or EL501).
O Unlimited number of door panels (access) being not necessary the use of switching units.
O Up to 120 monitors/telephones per installation or backbone.
O General door panel (EL501 mode): Up to 120 monitors/telephones, distributed in max. 120 buildings.
O EL560 module for video installations with twisted pair cable, integrated in EL500SE circuit.
O Communications resistor for the system UNO or PLUS, integrated in EL500SE circuit.
O Acoustic busy channel and call acknowledgement signals.
O Door opening timed at 3 seconds.
O Input for external door release push button (timed at 3 or 15 seconds).
O a.c or d.c lock release operated by relay.
O Up to 13 monitors or telephones in the same apartment, (see page 142):
wUp to 3 monitors or telephones (without additional power supply).
wFrom 4th to 8th monitor/telephone (1st additional power supply FA-Plus/C,
wFrom 9th to 13th monitor/telephone (2nd additional power supply FA-Plus/C,
O Common features for Platea/Tekna Plus monitors and T-740Plus telephones:
wPrivacy on audio communications.
w
Intercommunication function with other monitor or telephone of the same apartment (only one
slave unit configured with intercommunication).
wInput for external door bell push button.
wOutput for additional call repeater.
wCall to a master porter's exchange.
wPanic call to the porter's exchange.
wDifferent call reception tones depending where the call is comming from: main or slave door
panels, door bell push button, intercom, ...
SAFETY PRECAUTIONS
SYSTEM CHARACTERISTICS
placed on technical cabinet
placed on technical cabinet
Continue
).
).
Publicidad
