golmar Stadio Plus T500SE ML Manual De Instalación página 53

DOOR PANEL INSTALLATION
A
ssembling the EL500SE microprocessed circuit
and the EL516SE push buttons encoders.
The EL500SE circuit is to be assembled on the top of
the embedding box. Insert the circuit in the top
flanges of the embedding box (1). Push-in the
circuit in the bottom flanges (2) by pressing the pcb
board.
To assembly the EL516SE encoder, screw the top tab of the
case to the corresponding plastic lug of the embedding
box.
In case of more than one encoder, place them underneath or
in the next embedding box.
The use of EL516SE encoders is only necessary for panels
with more than 8 push buttons. Each encoder allows to
connect 15 push buttons, obtaining a maximum of 120
push buttons by using 8 encoders.
103
A
ssembly the sound module.
Insert the sound module in the grille module. For
a proper assembly, align the light push button
and the microphone rubber of the sound
module with its corresponding holes in the
grille module.
1
2
104
DOOR PANEL INSTALLATION
H
old the door panel on the embedding box.
Select a direction to open the door panel; this selection should ease the
door panel wiring. The opening direction will be settled through the
hinges position, that must be passed through the header clips as
shown. For example, if the hinges are placed on both clips of the
lower header, the door panel will open downwards; if they are
placed on the right clips of both headers, the door panel will open to
left.
To hold the door panel on the embedding box,
insert the hinges in the embedding box
lockers as shown.
Link the sound module with the EL500SE
microprocessed circuit by using the supplied
flat cable.
P
lace the label (informative window).
Before connecting the circuit of the informative
window (if it exists) for the indication of busy
system, should place the identification label.
insert a flat screwdriver to lever the flange to
access to the place of the label. Once put the
label replace the circuit.