Sauder Cannery Bridge Serie Instrucciones De Montaje página 17

Step 11
å
Fasten four EXTENSION RAILS (1) to the ENDS (A and B). Use twelve 3/8" FLAT HEAD SCREWS (25).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the ENDS. Turn a SCREW
into these holes.
25
431315
3/8" FLAT HEAD SCREW
(12 used in this step)
Open end
1
1
B
1
www.sauder.com/service
25
A
1
Open end
Page 17