Sauder Cannery Bridge Serie Instrucciones De Montaje página 26

Step 20
å
Before fastening the DOOR to your unit, be sure the mounting screw is
against the outer end of the slot as shown in the right diagram. If it isn't,
loosen the adjusting screw and mounting screw to slide it against the end of
the slot. Then tighten the mounting screw.
å
Fasten the DOOR (S) to the LEFT END (A) as shown in the lower diagram.
Use the screws in the HINGES. You should start each SCREW a few turns
before completely tightening any of them.
å
Peel the BUMPERS from the BUMPER CARD (15). Stick the BUMPERS on the
DOOR where it comes into contact with the UPRIGHT (C) and BRACE (H).
å
See the next step for DOOR adjustments.
15
S
15
Page 26
H
A
C
www.sauder.com/service
17
Stop
Mounting
screw
Adjusting
screw
Hinge
431315